Commented Issue: Preventing Hibernation [1554]

I am unable to prevent my computer from going into hibernation when a conversion task is running. Allow 'Sleep' is not checked and that does seem to prevent the computer from going into Sleep, but not Hibernate.

I'm running the service on an HTPC which is supposed to hibernate when idle for five minutes and I can't seem to figure out a way to keep it awake while the conversion is running short of disabling hibernate.
Comments: ** Comment from web user: rboy1 **

if you're running on batterries MCEbuddy cannont prevent standby. I've never tested Hibernation. Does it prevent it from going into STandby?

Also check the documentation:

Make sure Wake Timers are enabled in the system. Follow the steps below to enable Wake Timers.
1. Open the Control Panel (start -> Control Panel)
2. Look for Power Options and open it
3. For the active plan (the plan with the dot next to it), click on Change Plan Settings
4. Click on Change Advanced Power Settings
5. Click on the + next to the Sleep option
6. Click on the + next to Allow Wake Timers
7. Set the option to Enable for On Battery and Plugged In
8. Click OK